Lattice MachXO2 reset

by Cal-linux   Last Updated October 09, 2019 14:25 PM

After reading about GSR/PUR facilities in Lattice FPGAs, I'm still a bit puzzled about how to actually get the proper GSR/PUR-based reset functionality on an actual physical FPGA chip.

In the How to Use GSR and PUR application note, they show this Verilog example:

GSR  GSR_INST (.GSR (<global reset sig>));

suggesting that .GSR corresponds to an input, thus <global reset sig> would be mapped to an external pin (as I understood it).

But then, how do I use the output of that GSR_INST ? I distinctly remember that they say that the reset is active-low given the underlying circuitry. However, in the HDL Coding Guidelines, page 38/39, they show (Verilog version):

reg[1:0] state;
reg dout;

always @(posedge clk or posedge rst)
    if (rst) begin
        state <= idle;
        dout <= 1'b0;
    end
    else begin
    case (state)
    // ยทยทยท

That rst looks like an active-high reset signal (otherwise the code wouldn't make sense / wouldn't work). So, is rst a reserved keyword that corresponds to the output of the GSR_INST, and it is implicitly available anywhere I need it?

In short: how do I put the pieces together? (taking advantage of the GSR functionality, that is). I'm ok with or without automatic/implicit power-up reset (I can externally assert the reset pin of the FPGA for a few milliseconds after power-up). But I would still like to know about how to set it up both ways.



Related Questions


Updated November 06, 2018 16:25 PM

Updated November 22, 2018 19:25 PM

Updated April 17, 2016 08:10 AM

Updated June 17, 2019 22:25 PM

Updated September 15, 2019 20:25 PM