Inverter Circuit using IR2113, TLC555 and signal inverter IC

by Dasun Umayanga M. A.   Last Updated September 11, 2019 08:25 AM

Input DC = 30V

operating frequency = 10kHz

problem = When I am at the no-load condition at the output, only the oscilloscope is connected, I am receiving the proper output. But when I connect a load, which is a 10 Ohm resistor, the output voltage drops down to almost zero.

I really need a bit of professional advice here.

schematic



Related Questions


Updated March 31, 2017 23:25 PM

Updated July 24, 2016 08:10 AM

Updated December 29, 2018 23:25 PM

Updated May 02, 2019 17:25 PM