broken UV filter lens Canon lens EF70- 300mm f/4-5.6 IS USM

by 70milfordst   Last Updated December 18, 2017 17:18 PM

like so many others I broke the UV filter lens on my Canon lens EF70- 300mm f/4-5.6 IS USM. I'm finding it difficult to remove the filter lens as the threads seem to have been warped with the breakage impact. Any suggestions?

Tags : canon filters uv

Answers 5

You'll need a filter wrench. They are relatively inexpensive to purchase. You'll need get one that is the correct size. Also, most camera shops would probably help you remove it without charge.

Mike Dixon
Mike Dixon
December 18, 2017 17:15 PM

If you can pick up a filter wrench that generally works well.

In a pinch, I find I can get enough traction by putting a rubber band around the filter then unscrewing the filter using the rubber band as a grip. This works especially well if you can slightly overhang the rubber band over the grip ridges on the filter ring.

If the damage was enough to warp the filter rings you might need to get the lens checked...

December 18, 2017 17:25 PM

If the rubber band or filter wrench doesn't work, the next step is a precision band saw.

enter image description here

If Adam Savage (the guy in the video) and his band saw is not available, you could also use a needle file or hacksaw to create a couple of notches in the front of the filter ring.

Once you've cut a couple of notches in the filter ring, you can use a steel rule to twist it off.

enter image description here

If the filter ring is too distorted to twist it off with the metal rule, you're going to need to remove as much of the filter glass as you can and then peel it off with a pair of (locking) needle-nose pliers. It may be easier if you cut all the way through the filter ring. Yes, that will nick the lens' filter threads. But if they are already warped they're going to need to be replaced anyhow.

When using a file, hacksaw, needle-nose pliers, etc. on the filter ring, it's not a bad idea to place a soft cloth over the front element of the lens to minimize the risk of scratching it.

If the lens hit something hard enough to warp the filter ring, the front element of the lens and filter threads are the least of your worries. The internal lens alignment needs to be checked.

For more about the overall subject of To filter or not to filter (for lens 'protection'), that is the question, please see this answer to is uv filter a must? here at Photography at Stack Exchange. There are lots of links to a plethora of questions/answers here and resources elsewhere on the subject. While there are times and places (sand/dust storms, at the beach, industrial settings with hot metal particles flying off grinders, etc.) where filters are useful for protecting the front of the lens, in catastrophic incidents such as yours they tend to be liabilities more often than not. A lens hood is normally better impact protection without any of the optical penalties of a flat glass filter.

Michael Clark
Michael Clark
December 18, 2017 17:56 PM

I had this issue as well when I dropped my L-series. Cracked the Polaroid filter. I used a jar lid wrench to get it off (very carefully). The wrench has points that grip lids, so it bit into the filter ring.

The lens survived.

December 19, 2017 00:32 AM

I have had luck using a micro fiber cleaning cloth to grip the edge of stubborn filters. That would be a general-purpose terry cloth type micro fiber cloth and not the silky type used for lens cleaning. A wash cloth might also work.

December 19, 2017 01:08 AM

Related Questions

Updated August 29, 2016 08:07 AM

Updated August 28, 2016 08:07 AM

Updated January 10, 2019 15:18 PM

Updated April 22, 2016 08:07 AM

Updated September 12, 2016 08:07 AM